Exchange Currencies Track Order Guides Telegram bot

Swap Ethereum (ETH) to USD Coin Bridged (ARBUSDCE) with no sign-up

Enter the ETH amount, paste your 0x address on Arbitrum One from your own wallet, then send ETH on zkSync Era to the one-time deposit address on your order page. Once the zkSync Era network has confirmed the deposit, the exchange partner swaps it at the floating rate and sends ARBUSDCE on Arbitrum One straight to your address.

Swap ARBUSDCE to ETH instead

Rate
1 ETH ≈ 1,668.9553 ARBUSDCE
Network Fee
-
Deposit Fee
-

Enter an address on the Arbitrum One (ERC-20) network. Coins sent to an address on another network can be lost.

Swap in Telegram

No Account Needed to Start

Swap without creating an account or uploading ID. xswap.to never asks for your seed phrase or private keys, and the exchanged coins go straight to your wallet. In rare cases the exchange partner's compliance check can pause a swap and ask for verification.

Updated Written and checked by the xswap.to team

ETH to ARBUSDCE exchange rate

The ETH to ARBUSDCE rate on this page is an estimate for a real swap after fees, so it reads a little lower than the ratio of the two market prices. It floats with the market until your deposit confirms.

Type any amount into the calculator below for a live figure. The table under it shows what several ETH amounts come to in ARBUSDCE after fees. It is worked out from the page's latest quote and carries that quote's time.

ETH to ARBUSDCE Calculator

Enter an amount to see about how much you would receive. The estimate uses the live floating rate and already includes the payout network fee.

ETH zkSync
You get (estimate)
ARBUSDCE Arbitrum ERC-20
1,668.955317 ARBUSDCE
Rate
1 ETH ≈ 1,668.96 ARBUSDCE
Value in USD
≈ $1,715.57
Network Fee
0.0204712 ARBUSDCE

ETH to ARBUSDCE conversion table

Estimates after fees, worked out from one live quote taken at . The rate floats: the calculator and the swap form show the live figure.
You sendYou get (estimate after fees)
0.1 ETH≈ 166.562 ARBUSDCE
0.5 ETH≈ 834.292 ARBUSDCE
1 ETH≈ 1,668.96 ARBUSDCE
5 ETH≈ 8,346.26 ARBUSDCE
10 ETH≈ 16,692.9 ARBUSDCE
Live Market Snapshot Updated Nov 22, 2026 17:28 UTC
1 ETH price
$1,757.23
1 ARBUSDCE price
$1.03
1 ETH buys
1668.955317 ARBUSDCE

ETH to ARBUSDCE market price range

Over the last 30 days, 1 ETH was worth between 2,235.2 and 2,572.6 ARBUSDCE at market prices. Over the last 90 days the range was 1,871.2 to 2,773 ARBUSDCE.

Aug 9, 2026Low 1,871.2 · High 2,773 ARBUSDCENov 6, 2026

Market price of 1 ETH in ARBUSDCE over the last 90 days

Based on daily market prices, checked on Nov 7, 2026. This is not your swap rate: the estimate in the swap form includes fees and moves with the market.

How to swap ETH to ARBUSDCE

  1. Copy your ARBUSDCE address

    Open your wallet with Arbitrum One selected as the network and copy the 0x address from its receive screen. Paste it into Recipient Address and compare the first and last characters.

  2. Enter the ETH amount

    Type it in the form at the top. If it is under the pair's minimum, the form shows that minimum and one tap fills it in. The ARBUSDCE estimate under it already has the payout fee taken out.

  3. Send ETH to the deposit address

    Press Exchange Now. Your order page shows a one-time zkSync Era deposit address: send the amount you entered in one transaction. Send from a wallet switched to zkSync Era that holds some ETH there for gas, and check the network name on the confirmation screen before you approve.

  4. Follow the order until ARBUSDCE arrives

    The status moves from waiting to confirming, exchanging, sending and finished. Keep the transaction ID from the order page until the ARBUSDCE is in your wallet.

What the ETH to ARBUSDCE swap costs

Two costs come out of the estimate before you see it: the exchange margin and the Arbitrum One network fee for your payout. You pay the zkSync Era network fee yourself in ETH on zkSync Era, for ETH and tokens alike, unless an app's paymaster covers it; the fee depends partly on Ethereum gas prices, and your wallet estimates it. When you send ETH, the fee comes out of the same ETH balance on zkSync Era, so the wallet needs the amount you entered plus the fee.

The payout fee is a flat amount per payout, so it takes a larger share of a small swap, and the ARBUSDCE you get per ETH drops near the minimum. The facts table below lists the typical network fees and the minimum with the date they were checked.

ETH to ARBUSDCE at a glance

From live exchange data, refreshed hourly.

Item You send You receive
Asset Ethereum (ZkSync Era) (ETH) USD Coin Bridged (Arbitrum One) (ARBUSDCE)
Network zkSync Era Arbitrum One
Type Native coin ERC-20 token
Contract - 0xFF970A…DB5CC8
Memo / tag Not needed Not needed
Network fee (typical, checked Nov 22, 2026) ≈ 0.00021 ETH ≈ 0.02004 ARBUSDCE
Route Cross-chain: zkSync Era to Arbitrum One
Rate Floating, estimate shown before you send
Minimum to send (typical, checked Nov 22, 2026) 0.0004893 ETH
Account / ID Not needed to start a swap

How long the ETH to ARBUSDCE swap takes

The ETH to ARBUSDCE swap is three waits in a row: the zkSync Era network confirms your deposit, the exchange partner swaps it, and the Arbitrum One network delivers the payout. zkSync Era makes a block about every second, and the sequencer confirms your deposit once one includes it. It is final only after its batch is proven and executed on Ethereum, and the exchange partner swaps after the confirmations it requires. In rare cases the partner's compliance check pauses an order, which adds time. The stages in order:

  1. Deposit sent and seen

    Your wallet broadcasts the ETH, and the order page moves from waiting to confirming once the deposit is found.

  2. A zkSync Era block includes it

    Its batch is then committed to Ethereum, proven, and executed after a security delay, which makes it final.

  3. Exchange and ARBUSDCE payout

    The partner swaps the ETH and sends ARBUSDCE. The status reaches sending, then finished, and the payout hash appears on the order page.

  4. Payout lands on Arbitrum One

    Your wallet lists it once an Arbitrum One block includes the transaction, as long as the wallet is set to Arbitrum One.

Your ARBUSDCE address for the payout

Arbitrum One uses the Ethereum address format: 0x followed by 40 hexadecimal characters, the same address your wallet shows on Ethereum. Copy the address from your wallet's receive screen, not from your transaction history, where a scammer's lookalike address can sit next to yours, and compare the first and last characters after pasting. A payout sent to a wrong address cannot be reversed. Mistakes that cost a payout:

  • An exchange deposit address meant for Ethereum mainnet or Arbitrum Nova: the payout is sent on Arbitrum One, a separate chain.
  • An address at a wallet or exchange that does not support Arbitrum One: Arbitrum's FAQ says its team cannot recover such funds; only that wallet or exchange might.
  • A smart contract wallet address, such as a multisig, that exists on another network but not on Arbitrum One: getting a payout back then depends on deploying that wallet there.
  • A token contract address copied from Arbiscan instead of your own wallet address: tokens sent to a contract that cannot handle them can be stuck for good.

Receiving ARBUSDCE on Arbitrum One: address and memo

Memo or tagNot used on this network.
Block explorerarbiscan.io

More about swapping on Arbitrum One

Send ETH on the right network

On the sending side, send ETH only on zkSync Era, the network your order page names. ETH sent on another network does not reach the deposit address. ETH exists on more than one network, and each is a separate entry in the coin list. Choose the entry that matches the network your coins are on before you create the order.

After the ARBUSDCE arrives

The payout is an Arbitrum One transaction, not an Ethereum mainnet one, so a wallet set to Ethereum shows nothing of it; switch yours to Arbitrum One. The coins can be moved again once the transaction is in a block, and the transfer is final when its batch is final on Ethereum.

Moving the payout to Ethereum mainnet later takes a bridge. Through the official Arbitrum bridge, a withdrawal takes at least seven days because of the challenge period, and you then claim it on Ethereum with a transaction that needs ETH on Ethereum for gas. Your wallet may list the ARBUSDCE only after you add the token, and moving it later costs gas in ETH on Arbitrum One, so keep some ETH there.

If the address belongs to an exchange, check that it accepts this coin on Arbitrum One and what its minimum deposit is; for a token, it must support the same contract. Arbitrum tells exchanges to credit deposits only once they are final on Ethereum. To check the payout yourself, open the payout hash from the order page in an Arbitrum One explorer such as Arbiscan.

If your ETH deposit is slow or stuck

Look up the transaction hash on explorer.zksync.io. If it is not there, check which network your wallet sent on: the same 0x address exists on Ethereum, on other chains built with the ZK Stack and on other EVM networks, but the order waits for a transfer on zkSync Era only.

If the transfer is not on the explorer, check that the wallet held enough ETH on zkSync Era for the fee: unless a paymaster covers it, an ordinary account pays the fee in ETH, so a token send needs ETH beside the token. zkSync Era has no priority fee, so raising the tip does not move a transaction ahead.

Never send the deposit a second time to speed things up: a second payment is a second deposit. If the order page has not moved on after your deposit confirmed, message @xswap_to on Telegram with the Ref. ID from the order page and your deposit hash.

What others can see of your ETH to ARBUSDCE swap

Your deposit is public: the amount, your sending address and the deposit address show on explorer.zksync.io, and the resulting state changes are published to Ethereum. The payout, its amount and your receiving address are public on Arbiscan, where anyone who knows the address can see its whole history on Arbitrum One. The exchange partner that processes the swap sees both sides: your deposit and your payout address.

Before you send

  • Switch your wallet to zkSync Era and keep some ETH there for gas before you send, even when the deposit is a token.
  • Copy your ARBUSDCE address from the wallet's receive screen and compare its start and end after pasting.
  • Send the amount you entered in one transaction, and let your wallet add its network fee on top.
  • Bookmark the order page and save its Ref. ID, because the Track Order list is stored only in this browser.

ETH to ARBUSDCE Frequently Asked Questions

How do I swap ETH to ARBUSDCE?

Enter the ETH amount and your ARBUSDCE address in the form at the top, press Exchange Now, and send ETH on zkSync Era to the one-time deposit address on your order page. After the zkSync Era network confirms the deposit, the exchange partner sends ARBUSDCE on Arbitrum One to your address. No account or email is needed.

How much ARBUSDCE do I get for 1 ETH?

The amount table in the rate section shows it for several sizes, as an estimate after fees with the time of the quote. For your own amount, the ETH to ARBUSDCE calculator asks for a live estimate. No figure is written here, because the rate floats.

How long does ETH to ARBUSDCE take?

There is no set time: the zkSync Era network confirms the deposit first, then the exchange partner swaps it and sends the ARBUSDCE payout. The timing section on this page lists each stage, and the order page shows which one you are in.

Is there a minimum amount for ETH to ARBUSDCE?

Yes, every pair has a minimum, and it moves with network conditions. The facts table on this page lists the last checked figure. The swap form warns you when your amount is under the current one. A deposit below it cannot be swapped, and getting those coins back is not assured.

Can I swap Ethereum to USD Coin Bridged without KYC?

You need no account, and xswap.to asks for no ID. In rare cases the exchange partner's automated anti-money-laundering screening pauses a flagged swap and asks for verification, and the order then shows the status verifying. If that happens, message @xswap_to on Telegram with your transaction ID.

Why is the ARBUSDCE I received different from the estimate?

The rate floats, so the market can move between the estimate and the moment your deposit confirms. A different deposit amount changes the payout too: if your wallet took its network fee out of the amount, less ETH arrived than you entered.

How do I swap ARBUSDCE back to ETH?

Use the ARBUSDCE to ETH page, linked next to the swap form. It works the same way in reverse: paste a zkSync Era address, then send ARBUSDCE to the one-time deposit address.

About these numbers

The calculator and the swap form ask for a live estimate for the amount you type; if one fails to load, try again a few seconds later. The amount table is worked out from the page's latest quote and the network fees in it, so treat it as a guide and use the calculator for your own amount. Fees and the minimum in the facts table are typical figures with their check date.

Guides for this swap

Related swaps

Popular swaps