Exchange Currencies Track Order Guides Telegram bot

Move ETH from zkSync Era to Base

Enter the ETH on zkSync Era amount, paste your 0x address on Base from your own wallet, then send ETH on zkSync Era to the one-time deposit address on your order page. Once the zkSync Era network has confirmed the deposit, the exchange partner swaps it at the floating rate and sends ETH on Base straight to your address.

Swap ETH to ETH instead

Rate
1 ETH ≈ 0.977047 ETH
Network Fee
-
Deposit Fee
-

Enter an address on the Base network. Coins sent to an address on another network can be lost.

Swap in Telegram

No Account Needed to Start

Swap without creating an account or uploading ID. xswap.to never asks for your seed phrase or private keys, and the exchanged coins go straight to your wallet. In rare cases the exchange partner's compliance check can pause a swap and ask for verification.

Updated Written and checked by the xswap.to team

ETH on zkSync Era to ETH on Base exchange rate

The ETH on zkSync Era to ETH on Base rate on this page is an estimate for a real swap after fees, so it reads a little lower than the ratio of the two market prices. It floats with the market until your deposit confirms.

Type any amount into the calculator below for a live figure. The table under it shows what several ETH on zkSync Era amounts come to in ETH on Base after fees. It is worked out from the page's latest quote and carries that quote's time.

ETH (zkSync Era) to ETH (Base) Calculator

Enter an amount to see about how much you would receive. The estimate uses the live floating rate and already includes the payout network fee.

ETH zkSync
You get (estimate)
ETH Base
0.9770469 ETH
Rate
1 ETH ≈ 0.977047 ETH
Value in USD
≈ $1,663.81
Network Fee
0.0000028 ETH

ETH (zkSync Era) to ETH (Base) conversion table

Estimates after fees, worked out from one live quote taken at . The rate floats: the calculator and the swap form show the live figure.
You sendYou get (estimate after fees)
0.1 ETH≈ 0.0975175 ETH
0.5 ETH≈ 0.488419 ETH
1 ETH≈ 0.977047 ETH
5 ETH≈ 4.88607 ETH
10 ETH≈ 9.77234 ETH
Live Market Snapshot Updated Nov 22, 2026 06:48 UTC
1 ETH price
$1,700.93
1 ETH price
$1,702.89
1 ETH buys
0.9770469 ETH

How to swap ETH (zkSync Era) to ETH (Base)

  1. Copy your ETH on Base address

    Open your wallet with Base selected as the network and copy the 0x address from its receive screen. Paste it into Recipient Address and compare the first and last characters.

  2. Enter the ETH on zkSync Era amount

    Type it in the form at the top. If it is under the pair's minimum, the form shows that minimum and one tap fills it in. The ETH on Base estimate under it already has the payout fee taken out.

  3. Send ETH on zkSync Era to the deposit address

    Press Exchange Now. Your order page shows a one-time zkSync Era deposit address: send the amount you entered in one transaction. Send from a wallet switched to zkSync Era that holds some ETH there for gas, and check the network name on the confirmation screen before you approve.

  4. Follow the order until ETH on Base arrives

    The status moves from waiting to confirming, exchanging, sending and finished. Keep the transaction ID from the order page until the ETH on Base is in your wallet.

What the ETH on zkSync Era to ETH on Base swap costs

Two costs come out of the estimate before you see it: the exchange margin and the Base network fee for your payout. You pay the zkSync Era network fee yourself in ETH on zkSync Era, for ETH and tokens alike, unless an app's paymaster covers it; the fee depends partly on Ethereum gas prices, and your wallet estimates it. When you send ETH, the fee comes out of the same ETH balance on zkSync Era, so the wallet needs the amount you entered plus the fee.

The payout fee is a flat amount per payout, so it takes a larger share of a small swap, and the ETH on Base you get per ETH on zkSync Era drops near the minimum. The facts table below lists the typical network fees and the minimum with the date they were checked.

ETH to ETH at a glance

From live exchange data, refreshed hourly.

Item You send You receive
Asset Ethereum (ZkSync Era) (ETH) Ethereum (Base) (ETH)
Network zkSync Era Base
Type Native coin Native coin
Memo / tag Not needed Not needed
Network fee (typical, checked Nov 22, 2026) ≈ 0.00021 ETH ≈ 0.0000028 ETH
Route Cross-chain: zkSync Era to Base
Rate Floating, estimate shown before you send
Minimum to send (typical, checked Nov 22, 2026) 0.0008293 ETH
Account / ID Not needed to start a swap

How long the ETH on zkSync Era to ETH on Base swap takes

The ETH on zkSync Era to ETH on Base swap is three waits in a row: the zkSync Era network confirms your deposit, the exchange partner swaps it, and the Base network delivers the payout. zkSync Era makes a block about every second, and the sequencer confirms your deposit once one includes it. It is final only after its batch is proven and executed on Ethereum, and the exchange partner swaps after the confirmations it requires. In rare cases the partner's compliance check pauses an order, which adds time. The stages in order:

  1. Deposit sent and seen

    Your wallet broadcasts the ETH on zkSync Era, and the order page moves from waiting to confirming once the deposit is found.

  2. A zkSync Era block includes it

    Its batch is then committed to Ethereum, proven, and executed after a security delay, which makes it final.

  3. Exchange and ETH on Base payout

    The partner swaps the ETH on zkSync Era and sends ETH on Base. The status reaches sending, then finished, and the payout hash appears on the order page.

  4. Payout lands on Base

    Your wallet lists it once a Base block includes the transaction, as long as the wallet is set to Base.

Your ETH on Base address for the payout

Base uses the Ethereum address format: 0x followed by 40 hexadecimal characters. Copy the address from your wallet's receive screen, not from your transaction history, where a scammer's lookalike address can sit next to yours, and compare the first and last characters after pasting. A payout sent to a wrong address cannot be reversed. Mistakes that cost a payout:

  • An exchange deposit address meant for Ethereum mainnet or another layer 2 such as OP Mainnet: the payout is sent on Base, a separate chain.
  • An address at a wallet or exchange that does not support Base, which then cannot show or credit the payout.
  • A smart contract wallet address, such as a multisig, that exists on another network but not on Base: getting a payout back then depends on deploying that wallet there.
  • A token contract address copied from Basescan instead of your own wallet address: tokens sent to a contract that cannot handle them can be stuck for good.

Receiving ETH on Base: address and memo

Memo or tagNot used on this network.
Block explorerbasescan.org

More about swapping on Base

Which network your ETH on Base arrives on

This page pays ETH on Base. The same coin is listed on other networks too, each as its own entry in the coin list, and the links under this section open the ones open for payouts now.

Pick the entry before you press Exchange Now. The same coin on another network is a different asset to your wallet: balances do not carry over, moving it later takes another transfer, and an address on the wrong network can lose the payout. On the sending side, send ETH on zkSync Era only on zkSync Era, the network your order page names. ETH on zkSync Era sent on another network does not reach the deposit address.

After the ETH on Base arrives

The payout is a Base transaction, not an Ethereum mainnet one, so a wallet set to Ethereum shows nothing of it; switch yours to Base. The coins can be moved again once the transaction is in a block, and transfers within Base do not wait for the window that applies to withdrawals to Ethereum.

Moving the payout to Ethereum mainnet later takes a bridge. Through Base's standard bridge, a withdrawal can be finalized on Ethereum only after a window of 5 days, or 1 day when both of Base's proof systems back it, and proving and finalizing it are transactions on Ethereum. ETH is the coin that pays Base fees, so the payout itself covers gas when you move it, or anything else on Base, later.

If the address belongs to an exchange, check that it accepts this coin on Base and what its minimum deposit is; for a token, check the contract address it accepts, not only the ticker. To check the payout yourself, open the payout hash from the order page in a Base explorer such as Basescan.

If your ETH on zkSync Era deposit is slow or stuck

Look up the transaction hash on explorer.zksync.io. If it is not there, check which network your wallet sent on: the same 0x address exists on Ethereum, on other chains built with the ZK Stack and on other EVM networks, but the order waits for a transfer on zkSync Era only.

If the transfer is not on the explorer, check that the wallet held enough ETH on zkSync Era for the fee: unless a paymaster covers it, an ordinary account pays the fee in ETH, so a token send needs ETH beside the token. zkSync Era has no priority fee, so raising the tip does not move a transaction ahead.

Never send the deposit a second time to speed things up: a second payment is a second deposit. If the order page has not moved on after your deposit confirmed, message @xswap_to on Telegram with the Ref. ID from the order page and your deposit hash.

What others can see of your ETH on zkSync Era to ETH on Base swap

Your deposit is public: the amount, your sending address and the deposit address show on explorer.zksync.io, and the resulting state changes are published to Ethereum. The payout, its amount and your receiving address are public on Basescan, where anyone who knows the address can see its whole history on Base. The exchange partner that processes the swap sees both sides: your deposit and your payout address.

Before you send

  • Switch your wallet to zkSync Era and keep some ETH there for gas before you send, even when the deposit is a token.
  • Copy your ETH on Base address from the wallet's receive screen and compare its start and end after pasting.
  • Send the amount you entered in one transaction, and let your wallet add its network fee on top.
  • Bookmark the order page and save its Ref. ID, because the Track Order list is stored only in this browser.

ETH to ETH Frequently Asked Questions

How do I swap ETH on zkSync Era to ETH on Base?

Enter the ETH on zkSync Era amount and your ETH on Base address in the form at the top, press Exchange Now, and send ETH on zkSync Era to the one-time deposit address on your order page. After the zkSync Era network confirms the deposit, the exchange partner sends ETH on Base to your address. No account or email is needed.

How much ETH on Base do I get for 1 ETH on zkSync Era?

The amount table in the rate section shows it for several sizes, as an estimate after fees with the time of the quote. For your own amount, the ETH on zkSync Era to ETH on Base calculator asks for a live estimate. No figure is written here, because the rate floats.

How long does ETH on zkSync Era to ETH on Base take?

There is no set time: the zkSync Era network confirms the deposit first, then the exchange partner swaps it and sends the ETH on Base payout. The timing section on this page lists each stage, and the order page shows which one you are in.

Is there a minimum amount for ETH on zkSync Era to ETH on Base?

Yes, every pair has a minimum, and it moves with network conditions. The facts table on this page lists the last checked figure. The swap form warns you when your amount is under the current one. A deposit below it cannot be swapped, and getting those coins back is not assured.

Can I swap Ethereum to Ethereum without KYC?

You need no account, and xswap.to asks for no ID. In rare cases the exchange partner's automated anti-money-laundering screening pauses a flagged swap and asks for verification, and the order then shows the status verifying. If that happens, message @xswap_to on Telegram with your transaction ID.

Why is the ETH on Base I received different from the estimate?

The rate floats, so the market can move between the estimate and the moment your deposit confirms. A different deposit amount changes the payout too: if your wallet took its network fee out of the amount, less ETH on zkSync Era arrived than you entered.

How do I swap ETH on Base back to ETH on zkSync Era?

Use the ETH on Base to ETH on zkSync Era page, linked next to the swap form. It works the same way in reverse: paste a zkSync Era address, then send ETH on Base to the one-time deposit address.

About these numbers

The calculator and the swap form ask for a live estimate for the amount you type; if one fails to load, try again a few seconds later. The amount table is worked out from the page's latest quote and the network fees in it, so treat it as a guide and use the calculator for your own amount. Fees and the minimum in the facts table are typical figures with their check date.

Guides for this swap

Related swaps

Popular swaps